LTIB kernel booting problem

hai, I am sabarinath i am using LTIB MPC8555CDS_20061017-ltib.iso i customized the kernel and poted on MPC8555 series Channel card product name "SPTWIMAXCC1E" AMC Channel Card i copied the kernel in to the RAM in the Board But at the time of booting it got shucked please see below what steps i done Advance thanks and Regards..........

=> setenv bootargs root=/dev/ram rw ramdisk_size=12036 => tftp 1000000 uImage Speed: 1000, full duplex Using TSEC0 device TFTP from server 172.20.214.235; our IP address is 172.20.215.238 Filename 'uImage'. Load address: 0x1000000 Loading: ############################## ###################################

#################################################################

#################################################################

################################################################# ########## done Bytes transferred = 1378677 (150975 hex) => tftp 2500000 rootfs.ext2.gz.uboot Speed: 1000, full duplex Using TSEC0 device TFTP from server 172.20.214.235; our IP address is 172.20.215.238 Filename 'rootfs.ext2.gz.uboot'. Load address: 0x2500000 Loading: #################################################################

#################################################################

#################################################################

#################################################################

#################################################################

#################################################################

#################################################################

################################################################# ######################################################## done Bytes transferred = 2944091 (2cec5b hex) => bootm 1000000 2500000 ## Booting image at 01000000 ... Image Name: Linux-2.6.11 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1378613 Bytes = 1.3 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK ## Loading RAMDisk Image at 02500000 ... Image Name: uboot ext2 ramdisk rootfs Image Type: PowerPC Linux RAMDisk Image (gzip compressed) Data Size: 2944027 Bytes = 2.8 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK mpc85xx_cds_init(): exitcde000, end 0ffacc1b ... OK id mach(): done MMU:enter MMU:hw init MMU:mapin MMU:setio MMU:exit setup_arch: enter setup_arch: bootmem

After the above line its stucking not moving fully stucked please mail me problem of error..............

Reply to
sabarinath
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.