Its me again. Does anyone know of some good certifications to get qualified (or re-qualified) for an Embedded job?
I dont mean that the certs will do everything for me. I'm just thinking of something supportive as an extra.
Certifications for Embedded stuff?
Sep 07, 2010
4 Replies
First reply
Might depend a bit where you are in the world and what you already have under your belt qualification-wise. Embedded Systems work might need a very wide range of skills.
Read the full reply
formatting link
Vladimir Vassilevsky DSP and Mixed Signal Design Consultant
formatting link
Might depend a bit where you are in the world and what you already have under your belt qualification-wise. Embedded Systems work might need a very wide range of skills.
********************************************************************
Paul E. Bennett...............
Forth based HIDECS Consultancy
Mob: +44 (0)7811-639972
Tel: +44 (0)1235-510979
Going Forth Safely ..... EBA. www.electric-boat-association.org.uk..
********************************************************************
"Embedded" is too broad of a term. It's not like "accounting" where you can claim to be a CPA and "numbers are numbers".
Think about the *industries* you are targeting and what would make you more attractive to *them*. E.g., if you want to design consumer kit, then being able to design medical instrumentation is NOT going to be a big win for you...
I've found versatility to be a good asset -- showing that you aren't easily pigeon-holed but can adapt to new requirements, technologies, etc.
Good luck!
--don
How about an engineering degree from a good University?
Best regards, Spehro Pefhany
"it's the network..." "The Journey is the reward"
speff@interlog.com Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required