Arduino Uno + ATtiny2313

Za pomocą Arduino Uno udało mi się zaprogramować 2313 wg wskazówek na

formatting link
Jednej rzeczy nie rozumiem: po co ten kondensator 10uF w momencie wgrywania softu na ATtiny2313?

Cytat ze strony: "Connect a 10 uF capacitor from reset to ground on the arduino (negative side to ground)"

Bez niego też da się zapisać soft.

pozdrawiam inst4nce

Reply to
inst4nce
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.