Do you have a question? Post it now! No Registration Necessary
- Posted on
June 12, 2006, 11:06 am
rate this thread
I have designed and made a triac switch , to turn ON and OFF a 3-speed
AC motor that works with 220VAC.
with tree triac series an all the triacs have a snubber (R-C) circuit.
the problem is when the circuit is in OFF state , the triac outputs
shows that it has 220V voltage(with a Phase Meter screwdriver) .
but when i check with a multimeter it doesnt show any voltage. i know
that it doesnt have a real voltage but i dont know what is the problem?
- » A few questions about those WALKIE-TALKIE like radios....?
- — Next thread in » Electronics Design