My shopping list:
1 osc. f~1Mhz d~0.5
1 RS latch Td~ OUT IN1 >---- [ R Qbar]-----) (or NOR) IN2 >---- [ S ]
D from BC
1 osc. f~1Mhz d~0.5
1 RS latch Td~ OUT IN1 >---- [ R Qbar]-----) (or NOR) IN2 >---- [ S ]
Scared of Routing Hairball with Configurable Multiple Function Gates
Dec 26, 2007
3 Replies
1 osc. f~1Mhz d~0.5
1 RS latch Td~ OUT IN1 >---- [ R Qbar]-----) (or NOR) IN2 >---- [ S ]
SN74LVC1G98's.
formatting link
how bout a 74??00 or 74??02 type depends on your r-s ff active states. either can make an osc and common vcc cuts out the hairball al
SN74LVC1G98's.
formatting link
The R and S are active high. Bummer... :( Sucks up all the NORS in quad NOR package.
2 NORS to make an oscillator.And finally NOR #7, the final gate.
So.. 7 NOR's total and a NOR to spare.
2 chips and simpler pcb routing for the power bus.Ehhh...not bad... Might be better than routing a power bus for four 6pin chips..
D from BC
SN74LVC1G98's.
formatting link
Use both sides of the PCB.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required