Link below to the LPC313x reference schematic. I am designing a board based on this reference schematic.
Page-4 - What is the purpose of 0ohm resistor packs on the EBI data, address lines as well as on some of the control lines?
Page-3 - We are not using USB and ADC peripherals. If we are not using them, is it mandatory to give power to these peripherals and disable them in software? We would like to save on those bypass capacitors, ferrite beads, PCB traces and size.
Page-9 - What is the need for the buffer 74LVC2G07GW? Since there is a pull down (R154) why can't we connect ADM811's reset out directly to LPC's reset. We are not using JTAG, nReset_BRD, nReset_SUP4.
TIA,
-bhav