Folks, is there a simple way to display group delay in LTSpice without entering a formula?
In PSPICE it was G(x) but this no workie in LT.
Regards, Joerg
http://www.analogconsultants.com
LTSpice: group Delay
Sep 04, 2007
2 Replies
From a previous post of Mike E. answering Jim T.
Robert H.
************************************** Jim,
Move the mouse to the right of the right axis. The mouse cursor turns into a vertical ruler trying to indicate that you're pointing at that axis' attributes. Left mouse click. Then check the group delay radio button under representation. All three axes attributes are edited in a similar mouse syntax.
--Mike
Aha! Thanks, this does the trick. AFAICT this feature was mentioned nowhere in the PDF manual but I might have overlooked it.
Regards, Joerg
http://www.analogconsultants.com
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required