I have an application that requires Totem pole type drivers to deliver ~1A for
High density drivers?
Feb 17, 2007
2 Replies
How much output voltage? There are some SO-8 (or dip8) dual mosfet gate drivers that might work.
What's the application?
John
The loads are 5-6 ohms each and there's one set of drivers on either side, so we need whatever voltage is required to drive a little over 1 amp through the load (accounting for the RdsOn of the gates or the diode drops of transistors (if we're using them)).
I was using some dual Mosfets up till now without any problems (in an even smaller package actually), but I'm looking for something denser if possible.
Dave.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required