This pump should be enough to cool the induction heater coil:
formatting link
Had some discoloration of the copper, this will allow for higher loads.
Flowrate test for cooling induction heater coil
Dec 19, 2015
8 Replies
I don't think my induction cooker has water cooling... So I wonder why you have this heat problem already at this relatively low power.
By the way, I already had found out that slow cooking an egg produces the best result, once on a gas burner, when the container (gastankje) was almost empty. I just guess the fransoos was earlier. :)
joe
On a sunny day (Sat, 19 Dec 2015 15:32:25 +0000) it happened Joe Hey wrote in :
If you melt solder in a container in the coil, as I did, then the generated heat colors the coil. It may be even worse with plutanium, aluminum, etc,
See also
formatting link
A carbon blanket was 12 $ or so on ebay. the pump much less. And the pump may come in handy for other experiments.
I once had one of those campinggas tanks / burners, used it for soldering copper tubing, put a new tank in, and it started leaking (bad rubber probably), and I had to take it outside and let the gas evaporate, and keep the neighbors away. I do not like gas. Trickity any time.
Changed nick again? ;-)
Still running Linux!
Nou ja, die Fransen kunnen best lekker eten maken.
Yeah, they call me joe now. :)
Always, at least for the last 20 years...
Oui!
joe
On a sunny day (Sun, 20 Dec 2015 13:47:32 +0000) it happened Joe Hey wrote in :
Heb net nog een eitje gebakken op dat ding, gaat al veel beter. Ga nu op zoek naar 2 11.5 lipos, die samen met mijn huidige lipo in serie for 3 x 11.5 V = 34.5 V goed zijn. Dan weer opladen met het zonne paneel. Heb een 'up converter' van ebay die dat moet kunnen:
formatting link
paneel is 80 W.
Nou ja, die cellen monitoren ;-) is dat nou echt nodig? ?? ;-) De RC lipos zijn 20x discharge en 2.2 Ah, dus 20 A ontladen moet kunnen.
google translate: Just added a fried egg on that thing , is much better. Go now looking for two 5.11 lipos , together with my current lipo in series for 3 x 11.5 V = 34.5 V are good. Then charging with the solar panel . Have an up converter ' ebay who should be able to :
formatting link
panel is 80 W. Well, that monitor cells ;-) is that really necessary ? ?? ;-) The RC lipos are 20x discharge and 2.2 Ah , so 20 A discharge should be .
WOW! 11.5 becomes 5.11, google that is a BAD mistake!
Do you speak english?
joe
Oops sorry, missed the translated part.
11.5, Google must have understood 11th of May, or May 11: 5/11.joe
On a sunny day (Sun, 20 Dec 2015 16:12:02 +0000) it happened Joe Hey wrote in :
Nein
On a sunny day (Sun, 20 Dec 2015 16:14:20 +0000) it happened Joe Hey wrote in :
Ach so!
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required