Electronics Down Under

  1. Home
  2. Electronics Down Under
5133 Threads Posts
to

light mixing kit wanted

I'm looking for a kit that has a single knob to control the intensity of red, green and blue light and thus produce any...
4 comments posted 20yrs
posted by rickm
4 comments posted 20yrs posted by rickm

capacitor with one long leg and one short leg

I am trying to assemble a DIY 1 watt amp kit set. It comes with some capacitors that each one has one long leg and one...
4 comments posted 20yrs
posted by ok
4 comments posted 20yrs posted by ok

Looking for a low noise AMP chip.

Hi All.I'm looking for a very low noise amp chip, about 1 watt is all I need. I have used the LM386 (crap) and the TDA2...
0 comments posted 20yrs
posted by r
0 comments posted 20yrs posted by r

Produce 110V at 60cps

I would like to buy an IBM electric clock from the United States. I understand that the "modern" ones ran directly from...
13 comments posted 20yrs
posted by david
13 comments posted 20yrs posted by david

Re: Philbot project

I'm in. FB
3 comments posted 20yrs
posted by nobody
3 comments posted 20yrs posted by nobody

7805 light load benaviour

Just to let people know that I'm working through the problem with low load benaviour of 7805 regs thoroughly, and will...
4 comments posted 20yrs
posted by bxvarley
4 comments posted 20yrs posted by bxvarley

Re: PHIL ALLISON

wrote Hi Phil Last evening, I directed some questions to you regarding the arrangements currently in place for your car...
2 comments posted 20yrs
posted by brian.goldsmith
2 comments posted 20yrs posted by brian.goldsmith

Car and Deep Cycle (Including SLA) Battery FAQ

The Car and Deep Cycle Battery FAQ has been updated. The most current version is 5.6 and can be found on www.batteryfaq....
0 comments posted 20yrs
posted by info
0 comments posted 20yrs posted by info

Blue Ant Abortion?

** Hi to all, I know someone who is the proud owner of one of these: http://www.blueant.com.au/supertooth2.htm He rang...
9 comments posted 20yrs
posted by philallison
9 comments posted 20yrs posted by philallison

Cost to install 15A GPO?

Afternoon guys, I have purchased a used 1600W UPS that requires 15A GPO. I currently only have standard 10A GPO's where...
19 comments posted 20yrs
posted by buzz
19 comments posted 20yrs posted by buzz

sheelding

how do i sheeld a normal EI transformers magnetic feild from audio circuits within a metal rack cace? would a sheet of m...
26 comments posted 20yrs
posted by dingding
26 comments posted 20yrs posted by dingding

About HT12D

Dear All, I am using a HT12E & HT12D with a RF transmitter and a RF receiver to do a radio transmission link. Two seria...
0 comments posted 20yrs
posted by send_to_lok
0 comments posted 20yrs posted by send_to_lok

Combining/Fusing GPS, Pressure, Height data

I have a RC model airplane, currently carrying a RC receiver, 900MHz radio modem, temperature sensor, pitot and static...
9 comments posted 20yrs
posted by <Falco>
9 comments posted 20yrs posted by <Falco>

7805 regs under low load conditions

Hi, I have a device that runs on 5V, load current normally about 8mA, but with periods of up to 30 - 50mA. Power supply...
13 comments posted 20yrs
posted by bxvarley
13 comments posted 20yrs posted by bxvarley

Newbie UART question. Thanks

I would like to connect two AVR 8535 uC with UART serial link by TxD and RxD. I am using BASCOM-AVR. I can use "print"...
3 comments posted 20yrs
posted by ljk
3 comments posted 20yrs posted by ljk