Translucent gradient letters with a hidden white diffuser

Nov 14, 2026 Last reply: 3 hours ago 3 Replies
Jump to replies (3)

The detail that caught me off guard is that the letters do not glow evenly because of the filament alone. White PLA plates sit inside each letter, and their whole job is to turn the dots of the addressable LED tape into one continuous glow. The outer letters are translucent gradient PETG, so the two materials work together: one carries the light, one smooths it out. That is a neat trick I had not considered before.



The maker of Not Too Shabby Creations walks through the whole design path in Fusion, starting in Inkscape. The lowercase letters nts are typed in a graffiti-style font, adjusted with strokes, converted from object to path and ungrouped, then repositioned by hand and exported as an SVG. In Fusion, the artwork is scaled against a 150 mm reference box, a baseline is added along the bottom so the sign stands upright, and the sharp inward points on the letters are trimmed. The main outline is extruded 40 mm and hollowed out with the Shell command down to a 1 mm wall.



Several small choices stand out to me. The diffuser faceplate is built with negative 0.3 mm offsets for clearance, extruded to 39 mm and shelled to 1 mm, and a 3 mm retention ridge inside the outer shell holds it in place. Circular holes and vertical drop slots are cut through the dividing walls and back wall to route the strip wiring and power cable. A miniature microcontroller development board with a USB-C port runs it, and the soldering was done with a soldering station and helping hands. The translucent gradient PETG filament is 1.75 mm.



The one part I would like more detail on is the layout of the tape inside each letter, since the trimming of the sharp inward points seems to shape where the light can reach. Even so, the finished sign reads as fully lit letters with a genuinely even glow.



Project by Not Too Shabby Creations. Watch it on their YouTube channel:

formatting link


The negative 0.3 mm clearance on the faceplate is the detail I would highlight. Printing a snug internal part always risks a plate that will not seat, so building the clearance into the model instead of fixing it with a knife seems like the sensible way to handle it. Paired with the 3 mm retention ridge, the whole front plate is a clean, tool-free fit, which I think is the smartest bit of the design.

How is the addressable tape actually arranged inside each letter? With a graffiti-style font the shapes twist and overlap quite a bit, and after the sharp inward points are trimmed I am curious whether the strip runs in one continuous pass or gets segmented between the dividing walls. Also, does the white PLA plate sit against the full 39 mm depth or only partway in?

A variation worth trying: print a second faceplate in plain translucent PETG with no gradient, using the same negative 0.3 mm offsets and 39 mm extrusion, and compare the two side by side. With the same 1 mm shell and the same internal ridge it should drop straight in, and it would show how much of the even glow comes from the white PLA plates versus the colour blending of the gradient material.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required