Model - SHARP VC-MH64. This video recorder stops playing tapes, it used to get about half way through the tape but now only plays a few minuites before stopping. On rewinding the tape it is meant to automatically slow down before it gets to the end, this also doesn't work any longer. Any ideas ?
Video stops playing half way through tape.
Sep 06, 2005
1 Replies
DAZ9643
DAZ9643: Here are some guesses:
- Bad or dirty tape..... try others
- Dirty tape transport and heads.
- Bad clutch
- Slipping belts and/or pinch roller
- Dirty mode switch
- Bad tape motion sensors
- Bad idler mechanism
- Faulty back-tension mechanism
Go to the website for this newsgrouup at
formatting link
there, with some searching, you will find a wealth of troubleshooting and repair tips..... or if that doesn't help, TAKE it to a repair shop for, at the very least, a repair cost estimate so you can make an intelligent repair decision with facts instead of guesses
Best Regards,
Daniel Sofie
Electronics Supply & Repair
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
"DAZ9643" wrote in message
news:DAZ9643.1uy49r@news.diybanter.com...
>
> Model - SHARP VC-MH64. This video recorder stops playing tapes, it used
> to get about half way through the tape but now only plays a few
> minuites before stopping. On rewinding the tape it is meant to
> automatically slow down before it gets to the end, this also doesn't
> work any longer. Any ideas ?
>
>
> --
> DAZ9643
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required