Toshiba vcr model:M-68C plays for 5 seconds then stops

Jun 18, 2006 1 Replies

Toshiba 4 head hi-fi stereo vcr model:M-68C,year:Aug 1999,CSA File No:LL38329 (Samsung),pcb board model:M-685 (also VR8800),the vcr plays,fast forwards or rewinds for about 5 seconds.During play the idler wheel does not move only the capstan motor and pulley therefore the vcr eats tape. I cleaned the mode switch and inspected and cleaned the idler wheel assembly but no go,according to a repair tip from:



formatting link



for a model:M-65C it states that the take up reel sensor (photo interrupter) pcb location:PT601=Toshiba # 70796241 or generic # SG-105L is defective,is this true? if so can someone verify the part # for my model as the above part is for model:M-65C as I looked at the part # look up sites below but could not find it:



Part # lookup sites does not list it:



formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
$$Search?OpenForm



I also look for my model at these free Toshiba service manual download sites but could not find mine:



formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link
formatting link



formatting link
formatting link



Nor could I find it here:



formatting link
formatting link
formatting link
formatting link
formatting link



then click on "click here to see the files" followed by "video" followed by "products".Thanks in advance for help.



Sidney E-mail:sidneybek(at)yahoo.com Dartmouth,Nova scotia Canada



On 18 Jun 2006 06:04:28 -0700, snipped-for-privacy@yahoo.com put finger to keyboard and composed:

If the idler wheel does not move, then the takeup reel remains stationary. The uP detects this via the reel sensor and then shuts down the mechanism. In short, there appears to be nothing wrong with your reel sensor. Instead I'd be looking for a slipping belt or slipping clutch or sticky brake pads. Also check that all rotating parts move freely.

To assist in troubleshooting, and to avoid damaging your tapes, you could make a dummy "cheater" cassette and turn the reel(s) by hand.

See

formatting link

You should be able to find a point where the driving part is turning but the driven part is not. Test the torque with your fingers. If you suspect a motor, measure the voltage at its terminals.

- Franc Zabkar

Please remove one 'i' from my address when replying by email.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required