Does anyone know how to set the time on a Soundesign clock radio. It is model #7580ciy. It has a telephone with it and a single cassette deck. I have pressed the set time button and then the hour button, (same with the minute button) and the hour time will not change nor minute time. It is a digital time readout and probably from the 80s. The am/fm works on it and the cassette and phone. Patt
soundesign clock radio
Aug 17, 2008
4 Replies
You have to press the time set button and the hour or minute button at the same time.
Did you try holding the Set buttin in while pressing hour/minute?
-- sam | Sci.Electronics.Repair FAQ:
formatting link
Repair | Main Table of Contents:
formatting link
+Lasers | Sam's Laser FAQ:
formatting link
| Mirror Sites:
formatting link
Important: Anything sent to the email address in the message header above is ignored unless my full name AND either lasers or electronics is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.
That's what I just said. You stole my post. I sure hope you have a good lawyer because you're going to need one. A definite lawsuit and possibly a prison sentence, too.
It's the conductive rubber switches. Clean them according to the instructions in Sam Goldwasser's FAQ.
I have a different model from them, but when it was a few years old I mounted real switches in it where the contact pads used to be. Maybe more extreme than what you need to do, but it's worked for me for over 20 years.
Reply in group, but if emailing add another
zero, and remove the last word.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required