Does any one know why sound cuting out repaired cold soder joints now it says protect only ? Does anyone have a schematic for this sony str de-345 unit thanks. Could it be a bad transister .
- posted
17 years ago
sony str de-345
Loading thread data ...
- Vote on answer
- posted
17 years ago
Check your inbox. I have sent you a PDF of the relevant schematics. As far as your problem goes, first the obvious, make absolutely sure that you have not introduced any whiskers with your reworking of the bad joints, and second, are you retesting with the pcb and any rear panel connectors, screwed firmly back down to the chassis ? These STR series amps are notorious for giving a protect condition if not, due to the fact that several grounds on the pcb are only made to one another via grounding points screwed down to the metalwork.
Arfa
- Vote on answer
- posted
17 years ago
The ground screws were a problem years ago - now if it's a similar problem, it would more likely relate to a soldered ground connection associated with the rear panel. I agree the OP may have introduced a failure, though. Close inspection of his work is indicated, and the usual DC voltage checks to narrow down the protection problem. May very well wind up being over the OP's head to fix this one.
Mark Z.
- Vote on answer
- posted
17 years ago
Hi Mark
Well, I have sent the schematics directly to him as he requested, so it's in his hands now. I've heard nothing back so far ... I still fool myself on various amps with grounding issues - and how many years have I been at it ?? Just yesterday, I did a Pioneer amp that was intermittent as hell. To get at the board bottom involved taking it right out, and also removing the rear panel to get enough clearance to hinge it up. It was littered in obvious dry joints ( it looked like he dreaded lead-free solder ), so I reworked them all, and confidently stuck the board back in, screwed it back down, and put a couple of screws into the back panel just to hold it in place. I switched on, and it all worked ok - until I moved it on the bench that is ... It promptly cut out into protect. Several minutes of cursing later, I realised that a couple of the RCA jack assemblies had metal fingers up the fronts of them. Once the screws had been put in these to bond them firmly back to the rear panel, all was well, so this is something that the OP should definitely check, as you say.
Arfa