Got this from dicepackage"
Sorry for the triple post but I waited to long for a response so I ended up just buying the GT321XA-BH board from shopjimmy.com. I was able to get my tv working by switching out the board for the new Polaroid one. Here is what I did:
Before I removed the old JL321XA board I took a picture of everything connected to refer to in case I had any problems reconnecting anything. I ordered the GT321XA-BH Polaroid board from shopjimmy.com. When I installed it I made sure to reconnect everything the way it was before. I also made sure that the jumper was in the up position to make sure it was getting the correct voltage. The jumper was in the exact same place but had a sticker over it so I didn't see it at first. I reconnected everything and at first nothing happened. I realized I didn't push the board in far enough and the parallel port looking connection on the back wasn't fully connected. I screwed the back panel in a bit to get some of the parts to stay in place and it worked when I powered it on. I also had to use a rotary cutter (dremel) to make room for the HDMI ports. It looks kind of ugly but it works. The only difference is it now thinks it is running a Polaroid board. Picture in picture no longer works with this board but on the plus side there is a second HDMI port. It also thinks I have a card reader and USB in the source options even though they aren't there.