The AG-A11 is a simple wired remote controller for Panasonic VCRs and camcorders. It has 7 buttons (RECORD, PLAY, REW, FF, STOP, PAUSE, AND SLOW) that each momentarily switch in a resistor to alter the current flowing in a circuit with a 4 volt DC internal supply. Does anyone have a table of the resistances used in this pushbutton controller? Thanks!!
Panasonic AG-A11 Wired Remote Control
Apr 09, 2005
1 Replies
Well, I figured out some of the values:
- STOP is 0 ohms
- REW is 1.6 kOhms
- FF is 5.1 kOhms
- PAUSE is 10 kOhms
Once paused, additional pushes of the same button causes the AG-5700 to step through the five SLOW speeds, and the 6th push restores PLAY.
What I can't figure out is what resistances are needed to switch from STOP to PLAY, directly to SLOW, and for REC. Any help will be appreciated.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required