Noise Suppression

When refrigerator starts up it spikes the line and devices get triggered.

Where can I find device to put in the refrigerator ac line to kill that noise ?

Links please.

Thank you !

Reply to
APlus
Loading thread data ...

Much more information is needed for a complete answer. A "Furman" line cond itioner with the capacity to handle a motor load will cost well in excess o f a new refrigerator that will not have this issue. If the motor-start cap acitor is failing, same issue as these are often sealed units. Applicable o nly to North America, of course.

So, where/what/age/brand/what is tripping, and how?

Otherwise, look up "true RMS line conditioner".

Peter Wieck Melrose Park, PA

Reply to
peterwieck33

You may try something like this :

formatting link

3300-joules~ISOBAR6

Hook it to the refrigerator to start with and if you still get devices tripping, put it on the devices.

Are you sure it is a spike or is it possiable the refrigerator is drawing enough current to drop the voltage ? A friend had a loose neutral on his power line. One side would have low voltage and the other would have high voltage. He had to get the power company to correct it.

Reply to
Ralph Mowery

Ralph:

A surge protector has only limited effectiveness on "outgoing" surges. Not none, limited.

Peter Wieck Melrose Park, PA

Reply to
peterwieck33

-------------

** That is extremely unusual - the fridge MUST be faulty.

** Now you change your story ?

A burst of "noise " is not a voltage drop that can trigger things. If the thermostat switch has no RC snubber, there is a burst RF noise that can make its way into audio gear as a click or a brief flash or data loss on a TV screen.

IME no plug in device is effective against this.

You need to add or replace the missing/ faulty snubber.

BTW:

Diagnosing your own problem and its cure is not welcome here.

Just describe the problem in detail and leave the rest open.

..... Phil

Reply to
Phil Allison

domestic or large commercial?

Reply to
tabbypurr

That was my first thought - wiring issue.

Reply to
John-Del

Hook the fridge up to a surge protector.

Reply to
bruce2bowser

Surge Protectors are designed to work on incoming power. Depending on the design, they are far less effective with outgoing surges. And, if you have, in fact, a drop in voltage due to a hard-start, the will have no effect at all.

Peter Wieck Melrose Park, PA

Reply to
peterwieck33

If it's the back EMF from the motor as I assume it will be, then it'll be a spike, not a surge, and that requires a different approach.

-- This message may be freely reproduced without limit or charge only via the Usenet protocol. Reproduction in whole or part through other protocols, whether for profit or not, is conditional upon a charge of GBP10.00 per reproduction. Publication in this manner via non-Usenet protocols constitutes acceptance of this condition.

Reply to
Cursitor Doom

It's more likely a spike from the motor current being suddenly shut-off. Remember motors are reactive components.

--
This message may be freely reproduced without limit or charge only via  
the Usenet protocol. Reproduction in whole or part through other  
protocols, whether for profit or not, is conditional upon a charge of  
GBP10.00 per reproduction. Publication in this manner via non-Usenet  
protocols constitutes acceptance of this condition.
Reply to
Cursitor Doom

A normal refrigerator motor turn-off doesn't have this effect. This is not normal, is most likely a wiring-in-the-walls fault. An electrician should check the power delivered.

Reply to
whit3rd

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.