This Icon unit is a ceiling unit for a car with an F6400TFT LCD monitor. The circuit board inside says Toshiba TED60W12B and 1H16950. The connections to it were cleanly cut- I want to connect power- 12 volts, and video. There is a tiny white connector on the control board, but no designations as to what the 4 or 5 pins are. Would anyone have a pinout of this or know where to make connections? Thanks for your help. mm
Icon f6400/ LCD Monitor/ ToshibaTED60W12B HELP
Jun 16, 2007
1 Replies
On Sat, 16 Jun 2007 22:25:36 GMT, "Michael Muderick" put finger to keyboard and composed:
Your first problem is to determine how many pins there are. :-)
The supply and ground pins would probably go to an electrolytic filter capacitor. The video input (assuming it is composite) may go to a buffer transistor and possibly a 75 ohm terminator resistor. Can you measure 75 ohms between any two pins?
Do you have a cable stub? If so, can you see a mini coax pair?
Can you post a photo of the PCB on your web space?
- Franc Zabkar
Please remove one 'i' from my address when replying by email.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required