Digitek Monitor (Hansol E17BL) "enlarge" then "shrink" problem

May 04, 2005 1 Replies
R

Hi!



I have a problem with my monitor, where the display of the monitor "enlarge" then "jumps" back to a smaller size (shrink) repeatedly. The difference is about 3 to 5mm all sides (top, bottom left right). However the center of the display remains unchange. I think when the problem begins this effect was at a slow rate then now it is happening at a rate of about once to twice a second.


I guess it is the problem of some of the DC supply has a faulty cap. Unfortunally I am unable to get hold a schematic. Does anyone have similar experience. Do you think I should continue to measure the caps using the scope or could the problem might something else, such as faulty fly back?


Thank You



Richard


Vote
Twitter Facebook LinkedIn
J

The main power supply, or high voltage supply is not regulating properly. This can be due to anything from a cold solder connection, to failing component(s).

You would have to get in there with a DVM, and start taking readings to see where the failure is. You will most likely need the service manual, if you are not familiar with the monitor.

I would strongly suggest that if you are not used to working in monitors, and properly trained to do so, that you should be aware of the extreme safety issues when going in to a monitor.

Jerry G. ======

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required