Why does my Pi 5 offline maps setup eat so much battery even with the screen off?

Nov 20, 2026 Last reply: 20 hours ago 4 Replies

First reply

TimberFox

That drain is normal for a Pi 5, so don't tear anything apart yet. The Pi 5 idles around 3 watts all by itself with nothing plugged in, and it has no real sleep mode. Your GPS module and that wireless dongle add a watt or so on top, plus the occasional fan spin. Run the math…

Read the full reply

So I finally got my little portable Pi project working, mostly. It's a Pi 5 in a hard case with a battery, a small touchscreen, and offline maps loaded up for when I'm out camping with no signal. Everything runs fine when I'm actually using it, but here's the thing that's bugging me.



When I shut the screen off and just let it sit, the battery still drains way faster than I expected. I figured with the display off it whould basially sip power overnight, but by morning it's dropped a noticable chunk, maybe 15 percent or so. The Pi itself is still running becuase I want the GPS to keep a fix, and I've got a little wireless dongle plugged in too.



Is that normal? I thought idle would be closer to nothing. My guess is the USB dongle and the GPS module are the culprits, and maybe the fan kicking on now and then. Someone mentioned underclocking or disabling certain services, but I'm not sure which ones are safe to turn off without breaking the GPS logging.



Any tips on what to check first before I go pulling things apart? I'd rather not sit there with a meter poking around if there's an obvious setting I'm missing.


That drain is normal for a Pi 5, so don't tear anything apart yet. The Pi 5 idles around 3 watts all by itself with nothing plugged in, and it has no real sleep mode. Your GPS module and that wireless dongle add a watt or so on top, plus the occasional fan spin. Run the math for your setup: if you're pulling 5 to 6 watts overnight, that's a chunk of watt-hours over 8 or 10 hours, and 15 percent off a typical battery pack is exactly what you'd expect. So the numbers line up with what you're seeing.

So the screen sleeping doesn't really matter much then, the box itself is the hungry part. I had something similar with a little media box I left running overnight and couldn't figure out why the battery was flat by morning. Never thought about the wireless stick pulling power the whole time even when nothing's using it. Does unplugging that thing while you sleep actually make a noticeable dent, or is it too small to bother with?

Worth checking wether the GPS module itself has a standby mode, because a lot of them keep the receiver hot even after they have a fix unless you send them a command to idle down between fixes. Mine sat there drawing full power all night til I set it to wake periodically, and the drain dropped noticeably without losing my track logs. Also look at what the wireless dongle is actually doing, since a lot of them stay associated with a network and wake constantly even when nothing is transferring. If you just need it for occasional file transfers, a small script that unbinds it from the USB bus when you are not using it works well and is easy to reverse when you want it back.

Update: tried pulling the wireless dongle overnight and the drain barely moved, so the receiver is doing most of the damage. I found a periodic wake setting in the config, seems to do what the third reply described. Two things I can't figure out though. Will the fix still be accurate if it only wakes every few minutes, and is there a way to stop the fan from cycling at all or is that normal?

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required