A 3D printable telepresence rover driven from a browser

Nov 08, 2026 Last reply: 1 week ago 3 Replies
Jump to replies (3)

The detail that surprised me most: this rover has no autonomy whatsoever, yet it still pulls into a floor dock and charges wirelessly over a puck lit blue. Everything about it is human-driven, and that restraint is part of the appeal. The maker, Nik Ivanov, built a machine that does one job well instead of pretending to think for itself.



The hardware is refreshingly simple. The chassis is 3D printable, shown in black and white, riding on four wheels with a front-facing camera module. A Raspberry Pi 3A+ serves as the main computer, paired with geared motors that use plastic gears, and a wireless charging pad rides onboard so the rover can top up on its dock. The upper enclosure carries a circular grille that appears to be for a speaker or fan.



Control happens entirely through a browser. You connect, drive with a keyboard, and receive audio and video while sending audio back. The interface presents a wide-angle feed, network telemetry, signal indicators, and audio controls. Trim can be set for either side, with deviation from bearing adjusted by hand. The startup greeting is text pushed through a configurable text-to-speech engine, which is a charming touch. Reported CPU load sat between 20.9 and 31.5 percent in use.



The trade-offs are stated plainly. The maker spent roughly two months trying to make a Raspberry Pi Zero W work before settling on the 3A+, and on the Zero W audio encoding alone consumes about half the CPU. Long-term durability of the plastic-geared motors is still an open question, though the maker finds the N20 motors quiet, especially the lower-RPM versions.



The rover was tested driving while carrying a can of beverage, and separately shown crossing hardwood and tile flooring. The whole project is shared through a GitHub repository.



Project by Nik Ivanov. Watch it on their YouTube channel:

formatting link


Running everything from a browser is the smartest call here in my view. No client app to install, no version headaches, and any device with a keyboard becomes a controller. The trade-off is that you depend on the local network holding up, which is why the signal indicators on the interface matter. I also like that trim is handled manually per side rather than hidden behind closed-loop magic.

Since there is no autonomous function, how does the rover actually line up with the charging puck? Is it purely the driver steering it into position until the pads meet, or is there any kind of alignment aid built into the dock or the camera view that helps with the final approach?

A TPU sleeve or soft TPE layer on the bottom of the charger base seems worth trying. A printed part sitting flat on hardwood or tile could slide when the rover pushes against it during docking, and a grippy bottom would anchor the puck in place. It is a small change that needs no redesign of the rover itself, just the dock.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required