14 discussions on ElectronDepot about the Atmel ATF1502BE: what owners asked, what went wrong, and what fixed it.
Specsmanship seems to be on the decline. Philips/NXP is usually top notch but the family guide for their LVT series is, gasp, three pages short. Information about maximum transition times on inputs: Zilch.In an embedded application I need...
Specsmanship seems to be on the decline. Philips/NXP is usually top notch but the family guide for their LVT series is, gasp, three pages short. Information about maximum transition times on inputs: Zilch.In an embedded application I need...
I was posting to the thread on the embedded clock in a Manchesterencoded bit stream and realized that the clock is not truely embeddedin the data stream. I say this because you still have to know theclock rate in order for it to work. The...
While working on my next book, I've built a small general-purposeprototyping board. This PCB is also intended to be useful for thoseprojects where someone says "please prototype this" and it requires amicro that's only available in SMD.Here...
Hi all,I'm looking for a single chip solution that integrates an Epson-like (135x family, e.g.) LCD controller and some flash with a modest MCU.The application needs at a minimum of2 bits per pixel and320 by 240 STN LCD control.Similar code...
Hi folks,I have a fairly simple synchronous logic circuit, using a handful of flipflops and gates, which ordinarily I'd breadboard using HC TTL. However, it needs an 80MHz clock, which is too high for such families.I suspect I might need to...