General Electronics

  1. Home
  2. General Electronics
5208 Threads Posts
to

Worth reading in General Electronics

Separate ground for *each* circuit?

I need to run six 12 ga circuits from the breaker panel to the new construction (4 bathrooms). Do I need to run one 12...
6 comments posted 23yrs
posted by dave-usenet3016
6 comments posted 23yrs posted by dave-usenet3016

LIGHT PROJECT HELP

I WOULD LIKE A TO BUILD A CIRCUIT TO ALLOW ME TO LIGHT 1-21 LIGHTS 6 VOLTS EACH.ONE AT A TIME BY PUSHING A MOMENTARY PU...
1 comments posted 23yrs
posted by ron
1 comments posted 23yrs posted by ron

SAMCOP motor driver + amplifier for RC1011

Hello everybody anyone out there get a SAMCOP driver on stock ? To drive and control stepper and servo motors via rs232...
0 comments posted 23yrs
posted by dk6px
0 comments posted 23yrs posted by dk6px

Ground outdoor outlet?

In an old home with ungrounded electrical system, my father wants to add an outlet on the outside of the house near the...
23 comments posted 23yrs
posted by dave-usenet3016
23 comments posted 23yrs posted by dave-usenet3016

Consequences of Bent Ground Rod

Would there be problem with bending the ground rod of a residential transformer at the half-way point at installation?...
2 comments posted 23yrs
posted by micah.houtz
2 comments posted 23yrs posted by micah.houtz

Balun - Lumped Component

I had posted some questions on baluns earlier. Thank you very much for all then information. I should have been more sp...
1 comments posted 23yrs
posted by sthim2003
1 comments posted 23yrs posted by sthim2003

Microwave ovens ?

Anyone got a good used for an old microwave oven ? I thought about a Tesla coil but I dont want to get into building cap...
8 comments posted 23yrs
posted by stayforthedayandgo
8 comments posted 23yrs posted by stayforthedayandgo

Increasing voltage from 5 (or 20) to 24.

How do you go about increasing voltage from a lower voltage to a higher voltage. This will be used to run a 24 volt step...
2 comments posted 23yrs
posted by shawn
2 comments posted 23yrs posted by shawn

Re: Need Help with Transients

You absolutely must use filter capacitors, and you really should use a full wave bridge rectifier. Since you have no in...
1 comments posted 23yrs
posted by aichipREM
1 comments posted 23yrs posted by aichipREM

ANN: Toner Transfer Booklet

I am finishing up a 20 page booklet on how to get better results with toner transfer techniques. I would like to have a...
0 comments posted 23yrs
posted by atpclogic
0 comments posted 23yrs posted by atpclogic

Help With Circuit Information??

Please view in a fixed-width font such as Courier. ________________ | _____|_____ ______ | | | R1 and R2 used as a )||...
1 comments posted 23yrs
posted by rgwg99
1 comments posted 23yrs posted by rgwg99