Most early low voltage Bi-Pin sockets used phosphor bronze leaf springs, which quickly lost temper, and gave a miserable performance as a long lasting socket. Here in Australia you see very few of the old spring types left. You do see a lot of the socket that has grub screws to tighten on to the lamp pins, and more grub screws to tighten on to the high temperature pig-tails. IMHO, no other method comes even close to giving you a reliable long term connection. Accept no substitutes!
Bill.
New socket installed. New lamp installed. Light once again!
I had no idea that these sockets were so standardized (well, the 2-pin configuration, yes, but not the outside dimensions, the screw holes center-to-center dimensions.
It was a breeze!
Thanks to all.
Doesn't sound like much of high tech problem to me. It is a sorry-sack-of-sh_t so-called EET student who is so damned dumb he has to post to usenet about this drivel....
On Tue, 22 Mar 2005 23:22:16 -0800, Fred Bloggs wrote (in article ):
Don't know where you got that information... not a student at all.
Usenet is where questions are asked and information is shared. If you don't like it... delete or killfile. Your choice.
Okay- so there are two "DaveC" posting to this newsgroup- the other one is the whining flake then.
EET = Egotistical Educated Technician.
Quote of the day. "I am never wrong, once i thought i was, but was mistaken"
the New Sockets
new for a longer period of time !
BTW I observed that "Chrysler" fills the cavities on some multi-pin Connectors with grease to improve the reliability of its Electronic Fuel-injection System ! I don't know if it is to keep out moisture from shorting out pins or for reducing contact resistance from oxidized contacts. I also found that some greases are conductive enough to short-out the "distributor breaker contacts" on Electronic Ignition systems, before "Hall-Effect" switches became standard.
Yukio YANO
Ford has done this since at least the early 1960s...on every vehicle of theirs I've owned. Never seen it on the few GM and Daimler ("the Chrysler is silent") products...had to add silicone grease myself (plugs, headlight connectors, ignitiion wiring especially).
Have you searched for a new socket?You might find one and cheaply, too, these halogen lamps are very common.If it's an expensive and nice lamp, it's worth asking the professional advice of an electrician.
-- Tzortzakakis Dimitrios major in electrical engineering, freelance electrician FH von Iraklion-Kreta, freiberuflicher Elektriker dimtzort AT otenet DOT gr ? "DaveC" ?????? ??? ?????? news: snipped-for-privacy@news.sonic.net...
pin
to
twist
own,
Have something to add? Share your thoughts — no account required.
Ask the community — no account required