XTREME DSP Development Kit2 JTAG Problem

Hi all, I m using the Xtreme DSP Development Kit 2 with Viretex 2 XC2V3000-4FG676 FPGA.

While doing JTAG cosimulation in Simulink, i got an error message:"Error configuring device: A problem may exist in the hardware configuration. Check that the cable, scan chain and power connections are intact, that the specified scan chain configuration matches the actual hardware,and that the power supply is adequateand delivering the correct voltage." Thanks for the help.

Reply to
Bryan
Loading thread data ...

if the fpga is stuck in reset (prog_b pulled low), then the jtag chain will fail. thats a start

Reply to
mtsukanov

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.