(reposting with catchier subject line and some changes...)
Hi,
We are trying to run the "Virtex4_PPC_Example_9_1" example program from EDK9.1.2 that has TestInterrupt.c routine (timer interrupt driving the LEDs and UART interface displaying the status.)
The LEDs on the board appear to flash quickly, but we're unable to speed up or slow down the clock using the 'f' , 's' inputs via the serial port.
Software: EDK9.1i on linux 2.6.17, parport jtag, "windrvr6" and "xpc4drvr" drivers and devices all there. We are able to update the bitstream from XPS.
We are also able to establish the connection to the virtex-4 Fx12 LC development board, (the message log says so. ) but we are getting the following error:
********************** ERROR:iMPACT:1062 - Can only assign files to devices between positions 1 to 2 ********************** (more of the logs are below.) **********************Google says nothing about "files to devices between"!
We ran "impact" through tje command prompt and tried to down the bitstream, by selecting various combinations of ("download.bit", "system.bit"), "TestInterrupt.elf " and ("system_bd.bmm" and "system.bmm").
Has anyone ever seen this? Any suggestions?
thanks and regards vijay
********************************************* More detailed message ********************************************* impact -batch etc/download.cmdRelease 9.1.02i - iMPACT J.33 Copyright (c) 1995-2007 Xilinx, Inc. All rights reserved. AutoDetecting cable. Please wait. Reusing 78018001 key. Reusing FC018001 key. Connecting to cable (Parallel Port - parport0). WinDriver v8.11 Jungo (c) 1997 - 2006 Build Date: Oct 18 2006 X86
32bit 12:08:05. parport0: baseAddress=0x378, ecpAddress=0x778 LPT base address = 0378h. ECP base address = 0778h. ECP hardware is detected. Cable connection established. Connecting to cable (Parallel Port - parport0) in ECP mode. Cannot access /dev/xpc4_0 - No such file or directory. Cable connection failed. Connecting to cable (Parallel Port - parport0). WinDriver v8.11 Jungo (c) 1997 - 2006 Build Date: Oct 18 2006 X86 32bit 12:08:05. LPT base address = 0378h. ECP base address = 0778h. Cable connection established. ECP port test failed. Using download cable in compatibility mode. Identifying chain contents ....Version is 0000 '1': : Manufacturer's ID =Xilinx xc4vfx12, Version : 0 INFO:iMPACT:1777 - Reading /opt/Xilinx91 i/virtex4/data/xc4vfx12.bsd...INFO:iMPACT:501 - '1': Added Device xc4vfx12 successfully.
----------------------------------------------------------------------
---------------------------------------------------------------------- Version is 1111 '2': : Manufacturer's ID =Xilinx xcf08p, Version : 15 INFO:iMPACT:1777 - Reading /opt/Xilinx91i/xcfp/data/xcf08p.bsd... INFO:iMPACT:501 - '1': Added Device xcf08p successfully.
----------------------------------------------------------------------
---------------------------------------------------------------------- done. Elapsed time = 0 sec. Elapsed time = 0 sec. ERROR:iMPACT:1062 - Can only assign files to devices between positions
1 to 2----------------------------------------------------------------------
----------------------------------------------------------------------
Done!