spartan 3 starter kit

Oct 07, 2004 1 Replies

Rate this thread:

Urban Stadler 21 years ago

i have a question: i have the sparten 3 starter kit from digilent. i use the ise web pack from xilinx and i would like to know what i have to do to programm the fpga so it loads my programm after power on. what i figured out so far is that i have to programm the onboard flash. but how? any jumper or software settings?

thanks urban

Vote

Markus Koechy 21 years ago

Urban Stadler schrieb:

formatting link

Chapter 10 and 11. FPGA and Flash are part of the onboard JTAG chain. The Xilinx iMPACT software should recognize them - provided that the Flash PROM is enabled (Jumper JP1).

Best regards,

Markus.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required