Hello,everyone!I made a design following the tutorial in the nios developkit and do the pin assignment as the example the factotry Idownloaded to apex board using quartusII .But I cannot download my executecode to the FPGA .The sdk shellannouce that waiting for the target.........why?Thanks.

nios-run: waiting for target.......?

Jul 26, 2004 1 Replies

Rate this thread:

longyin 21 years ago

Hello,everyone!I made a design following the tutorial in the nios develop kit and do the pin assignment as the example the factotry supplys.Then I downloaded to apex board using quartusII .But I cannot download my execute code to the FPGA .The sdk shell annouce that waiting for the target.........why?Thanks.

Vote

Jasmine Hau 21 years ago

Have you try to download your hardware configuration to APEX chip using JTAG first before you download your hardware design to APEX using UART???

Besides, have you erase the user configuration in flash memory content??? If i not mistaken... e180000 . . e1b0000 r180000

If still waiting for target...., try to press the reset button on the APEX board then observe what message on Nios SDK Shell....

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required