When I Run the NiosII project, there is sometimes this error info. in the console:
nios2-terminal: exiting due to ^D on remote
But Why? it is relative with the pointer ?
Thank you very much!
Nios II -- Why does this error occur ?
Sep 08, 2007
1 Replies
Hi, this is because your design send a ^D char to the JTAG UART,which is interpreted as 'quit' by nios2-terminal.
You should now find if ^D is expected from you target board or if it erroneous (noise problem ?).
Hope this will hep. Regards.
--
--------------------------------- --- -- - Posted with NewsLeecher v3.9 Beta 2 Web @
formatting link
------------------- ----- ---- -- -
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required