Hi,
For a quite large project dealing with Virtex 4, DDR2, gigabit ethernet and digital signal processing, I'm looking for a top of the bill design house in a far east country like india.
All tips are welcome.
Best Regards, Anom
Hi,
For a quite large project dealing with Virtex 4, DDR2, gigabit ethernet and digital signal processing, I'm looking for a top of the bill design house in a far east country like india.
All tips are welcome.
Best Regards, Anom
tip one - avoid India and China
Pozdrawiam.
-- RusH // http://randki.o2.pl/profil.php?id_r=352019 Like ninjas, true hackers are shrouded in secrecy and mystery. You may never know -- UNTIL IT'S TOO LATE.
Following recent (second hand) experience of designs done in India my tip is; try Australia then Europe or the USA, in that order :)
Mike Harding
They dont exist.. and the one's you deal with will cost you more in the final analysis than if you had it done properly here or in europe..
They exists, but not cheap. Low skill labor costs in China/India are USD$1 per hour. High skill labor costs are over USD$10 per hour, plus another USD$5 management/government fees. Another consideration is that unless you are planning on open-source, there is no way to protect your invested IP.
This is not what you asked for - these guys are in the US. They've done a good job for me in the past. They have experience with these sorts of designs and parts:
Chris
Hi,
I should be able to help you on this. I have over two decades of experience in developing state-of-the-art technologies in DSP, FPGA, Video, Embedded Systems etc and with 15 years of experience in India on these technologies, though for last 8 years I have been in the Silicon valley. I know very well the industries there. Send me details via e-mail if you are interested ( snipped-for-privacy@yahoo.com)
VRMS
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.