Initialising LPM_ROM

Has anyone had any experience of using LP_ROM modules in Lattice XPGA Devices? I have generated an LPM_ROM and loaded it with an initialisation file, the code compiles and the floorplanner shows that EBR's are being used for the ROM. However i can't seem to run a functional simulation in Modelsim, the data from the ROM stays at "UUUUUUUU" whatever the address signal is.

Thanks, Matt

Reply to
Matt North
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.