Hi,
I am a relatively inexperienced user of Labview. I have written a VI to
scan several channels on a 34970A using the 34901A multiplexer module to take voltage readings. I want to use a more accurate DMM than the internal one however so I have hooked up a Fluke 8840A to the agilent and I want the scanner to simply switch between the channels while the fluke actually takes the voltage measurements. How do I modify my existing VI so that it uses an external DMM? One of the driver VI's is 'configure external instrument' which i assume is the obvious option but i'm not sure where to insert this to modify the VI.
Thanks
Tom