I bought a cordless mouse that takes 2 AAA batteries. I found that these wear out after about 2 weeks and want to get rechargable batteries but the device says "only use Alkaline batteries" - does this mean that I cannot use rechargable NiCd or NiMH batteries? Will these batteries blow up my mouse?! :o)
-pat
Greetings Pat..
Of course it depends on how tight the voltage requirements are on the circuit. Why? Due to the fact that Ni-Cads, for example, have a voltage of 1.2v DC per AAA cell. 1.2v * 2 = 2.4V DC fully charged vs. 1.5 * 2 =
3v DC for alkaline. Now, would the lower voltage 'hurt' the mouse - NO.. In fact, I would tend to bet that it would work just fine.The Plan: The way to do this would be to get two sets (4 batteries) and an external charger that reverts to trickle charge after full charge is achieved. Run on one set and once the mouse starts to act 'squirrelly' due to exhausted batteries pull these out and replace them with the freshly charged set putting the exhausted set on charge. Cycling in this way will allow you to just rotate between fresh batteries.
A good source for batteries & small chargers:
Good luck.
G.
patrickpdk wrote:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required