Embedded Programming

  1. Home
  2. Embedded Programming
16390 Threads Posts
to

Worth reading in Embedded Programming

Denx Linux 2.6.19.2 and MicroSys CR825/PM827

Hi all, I use BuildRoot and Linux 2.6.19.2 (Denx kernel) on a MicroSys CR825/ PM827 board, but Linux didn't recognize m...
0 comments posted 17yrs
posted by gchauvet
0 comments posted 17yrs posted by gchauvet

Looking for ARM linux chip

Looking for ARM linux chip -------------------------- What I want is something readily available with 'normal' type of...
0 comments posted 17yrs
posted by website_has_email
0 comments posted 17yrs posted by website_has_email

Power MOSFET Circuit Help

What is the purpose of using a power MOSFET in the main voltage input of a circuit? Why not just directly connect the m...
4 comments posted 17yrs
posted by jmeyer
4 comments posted 17yrs posted by jmeyer

Toggling GPIO Pins very quickly

Hey everyone, I'm working with an MSP430f2012 chip and am tryign t generate a delta sigma bitstream using a gpio pin. U...
2 comments posted 17yrs
posted by nick.kani
2 comments posted 17yrs posted by nick.kani

Armaide v2.1 Release News

Version v2.1 of Armaide, the Oberon-07 development system targeting NXP's LPC2xxx range of 32-bit microcontrollers has...
0 comments posted 17yrs
posted by cfbsoftware
0 comments posted 17yrs posted by cfbsoftware

TV News Legend Walter Cronkite Dies at 92

TV News Legend Walter Cronkite Dies at 92 http://www.imdb.com/news/ni0883481/ Don... -- Don McKenzie Site Map: http://w...
5 comments posted 17yrs
posted by 5V
5 comments posted 17yrs posted by 5V

High Speed USB Host

I'm trying to find a micro controller that supports High Speed USB Host capabilities and also has at least 4 A/Ds on boa...
4 comments posted 17yrs
posted by christopher.m1.williams
4 comments posted 17yrs posted by christopher.m1.williams

EuroForth 2009 Conference

EuroForth 2009 Conference ========================= EuroForth 2009 is in the UK again. It will be held at the Universit...
0 comments posted 17yrs
posted by pjk
0 comments posted 17yrs posted by pjk

Failed emulation connection to target F2812

Hi, I am trying to perform Flash Programming onto F2812 target board with Parallel Port communication, with using SDFla...
0 comments posted 17yrs
posted by surnathma
0 comments posted 17yrs posted by surnathma

Ethernet transformer vs. RJ-45

Hello, I have seen in several layout guidelines that the Ethernet transformer should be placed as close to the RJ-45 co...
6 comments posted 17yrs
posted by eric.bogomolny
6 comments posted 17yrs posted by eric.bogomolny

HELP required floating point multiplier on FPGA

hi Good Day! I hope you all are fine. Actually i want to take some technical input. I want to build 10,000 floating poi...
1 comments posted 17yrs
posted by mir6
1 comments posted 17yrs posted by mir6

Good ZigBee Dev Starter Kit Recommendation Help

Greetings, I am looking to get started developing a short range low power device that will consist of a controller and...
2 comments posted 17yrs
posted by ggolan
2 comments posted 17yrs posted by ggolan

System ACE VHDL Model

Hi, I'm currently working on a interface to a CF-Card via a System ACE Controller. I was wondering if somebody already...
1 comments posted 17yrs
posted by Andreas.Wallner.etm07
1 comments posted 17yrs posted by Andreas.Wallner.etm07

Mains Relay pin-out

Hi, I'm looking for a PCB Relay which will switch the Mains to some load. I noticed that many relays that claims "Max S...
5 comments posted 17yrs
posted by zigbee
5 comments posted 17yrs posted by zigbee