Hi,
In MMC protocol, the timeperiod in between command and response is to 64 clock cycles. i.e. after receiving a command, the MMC card has t respond with in 64 clock cycles.
But the command is followed by a period of two Z bits (allowing time fo direction switching on the bus) and then by P bits pushed up by th responding card.
My question is, whether the responding card has to push up the bu immediately after the command followed by two z bits or it can take mor than two z bits to respond.
Please clarify me.
Thanks in advance.
regards, SAI KRISHNA.
This message was sent using the comp.arch.embedded web interface o
formatting link