1. Home
  2. Embedded Programming
  3. PIC & Ethernet

PIC & Ethernet

Hi Folks,

I'm an engineering student trying to get started with my senior project Basically, I want to communicate with a bunch of devices (and th Internet) using Ethernet. I did some research and found a fe micro-controllers with built-in Ethernet capabilities. However, thes require separate programmers that are quite costly. So I'm thinking o using a regular PIC chip that I can program using one of the programmer in our school lab. However, my biggest problem is to find a way to get PIC chip to communicate through Ethernet. Do you have any ideas o information as to how to get this to work? Any input would be greatl appreciated.

Thanks!

Reply to
codegeek
Loading thread data ...

Have you even tried Google? This problem has been solved many many times and there are designs, documents and lots of code freely available. A search for "ethernet pic" brought up loads of useful hits.

Reply to
Tom Lucas

Luminary Micro provide some ultra low cost dev kits for their processors that have build in MAC and PHY. They also provide source code. All you need to program it is a USB cable. A free compiler is also available.

I would consider using one the low cost development kits available from Microchips global distribution network, along with the source code and application notes that can be freely downloaded from their WEB site (along with their free compiler).

--
Regards,
Richard.

+ http://www.FreeRTOS.org
13 official architecture ports, 1000 downloads per week.

+ http://www.SafeRTOS.com
Certified by TÜV as meeting the requirements for safety related systems.
Reply to
FreeRTOS.org

Lot depends on at what level (how deep) you wish to apply. Some device with Ethernet ready and open src lib are their or u can take a micro controller and attach it with ethernet controller ic ( available from national semi and many others ) and develop whole ur own version.

Regards,

Reply to
Viral

Microchip sells a PICDEM.net 2 board which has a PIC18 processor and ethernet. You can go to their web site for more info.

Paul Bosselaers

Reply to
Paul Bosselaers

"codegeek" skrev i meddelandet news:ZLSdnXfG6fz7OIXanZ2dnUVZ snipped-for-privacy@giganews.com...

The AT91SAM7X with built in Ethernet, can be programmed using a serial or USB cable. The AT91-ISP (containing SAMBA) is free of charge from

formatting link
GCC for ARM is free of charge as well
formatting link
You can get a low cost development board from
formatting link 

--
Best Regards,
Ulf Samuelsson
This is intended to be my personal opinion which may,
or may not be shared by my employer Atmel Nordic AB
Reply to
Ulf Samuelsson

How much do you think is a reasonable cost for such a programmer?

Petter

--
A: Because it messes up the order in which people normally read text.
Q: Why is top-posting such a bad thing?
A: Top-posting.
Q: What is the most annoying thing on usenet and in e-mail?
Reply to
Petter Gustad

Petter Gustad wrote: Petter

-- A: Because I am unable to keep up with other people. Q: Why is top-posting such a bad thing? A: Top-posting. Q: I am most annoyed by usenet and e-mail,

Reply to
donald

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.