Transformer input wiring fot 120/230VAC

I have a two coil Transformer on for input, one for output and I am unsure about the 120/230 connections. It's a JAMECO 101864 Transformer, Input Voltage 115/230VAC, 50-60Hz Out

24V/3A I am not sure how to hook up to run on 115V. Just to know, I would like to understand the 230VAC connections, too. The mfr diagram looks like this: The O was a black dot. I see we are using proportional fonts and my diagram is not..

O |

1 -------- | > | | < > | < 2 -------> | < 115/230V | | < > | < > | | |

I had it hooked to a 24V WallWart at 1 & 2 (Input was metered @ 27.9V). Between 6 & 10 had 6.76VAC, 6 & 8 was 3.35, as was 8 & 10 I understand about the center tap, It's just the 115/230 hookups that have me baffled. Thanks in advance for any help; Don

Reply to
Donald Bauer bellsouth
Loading thread data ...

O |

1 -------- | > | | < > | < 2 -------> | < 115/230V | | < > | < > | | |

For 115, connect 1 to 4, connect 2 to 5, connect AC to 1(4) and to 2(5).

Test on your AC 24V WallWart but this should be correct.

Reply to
Homer J Simpson

--
For 120V in, connect pins 1 and 4 together, pins 2 and 5 together,
and then connect the mains across pins 1 and 2 or across pins 4 and
5.

For 240V in, connect pins 2 and 4 together and then connect the
mains across pins 1 and 5.
Reply to
John Fields

Reply to
Donald Bauer bellsouth

Thanks John, this dummy appreciates all the help!

unsure

using

Reply to
Donald Bauer bellsouth

your diagram is perfect.

for 115V operation: O | ------+-- 1 -------- | | > | | < | > | < .--|-- 2 -------> | < | | 115V | | < | > | < | > | | | primaries in parallel for 230V operation O | --------- 1 -------- | > | | < > | < .-- 2 -------> | < | 230V | | < > | < > | | | primaries in series.

Bye. Jasen

Reply to
jasen

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.