I would like to use a dynamic mic with my computer which normally takes an electret microphone. How would i go about making a modification to achieve the above?
Dynamic Microphone Modification?
Mar 08, 2005
1 Replies
Electret mics need a supply voltage, which your dynamic mic doesn't want to see. The supply voltage is usually on the "ring" part of a stereo connector used for the (mono) mic. So if you just wire up your connector using only the tip and sleeve, you should be OK.
Best regards,
Bob Masta dqatechATdaqartaDOTcom D A Q A R T A Data AcQuisition And Real-Time Analysis
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required