I need to create a special wire holder that will allow me to hold down and solder multiple leads to a PCB, and I just wanted to get opinions on what would be the best material to use for this.
Am I correct in assuming that molten solder will not stick to cured ceramics(or perhaps a heat resistance glass)?
If so, I'll just need to find a way to grind/form the part/s I'll need.
Thanks a lot.
Darren Harris Staten Island, New York.
down
need.
Hi, Darren. Make it easy on yourself, ceramic/glass is too much work, although it would probably work well. One negative, though, is that thermal shock might cause fracturing.
Any metal that doesn't "wet" will work fine as a clip to hold down wires. Aluminum is easily machined, but it's also very good at absorbing heat, and may act like a heat sink. Steel is another good choice, as it doesn't absorb heat as readily. I've used both.
If you'd like to make it out of wire, piano wire is a good choice. Sometimes the springiness is a big plus in fixturing, and it won't wet, either.
Good luck Chris
opinions
work,
wet,
Thanks, but this must be a solid material.(I'm soldering rows of leads to fingerboards).
And since it will have to lay over the insulated part of the leads, it obviously cannot have a high heat conductivity.
And lastly, the material hs to be at about 1/8" thick, in which I'll need to be able to cut rows of grooves that are .156" in width.
Basically, the grooves would have to be wide enough to hold the wire, and deep enough to keep the molten solder in place. This would enable me to quickly go down the line soldering each lead down to the PCB.
Thanks a lot.
Darren Harris Staten Island, New York.
-- make it out of Teflon.
The other cool material is Corian, the stuff they make kitchen countertops out of. It's very heat resistant and a dream to machine, as nice as delrin. And home improvement places give away 3" square chunks as color samples! Find a place that does the counters and buy some scraps or dumpster dive, maybe.
John
--I worked on a wave soldering machine once; the part carriers, which had to remain solder-free were made from titanium.
-- "Steamboat Ed" Haas : Blah blah blah blah Hacking the Trailing Edge! : blah blah blah...
Teflon (PTFE) might work here. Good at high temperatures, but a bit of a bitch to machine.
Available in sheet, rod, tube, in many sizes. Talk to an engineering plastics company.
--
Then there's duct tape ...
(Garrison Keillor)
You might want to do a Google search for "hot bar" soldering. This is a process used for soldering flat flexible cable to PC boards using a heating element that solders all the wires at once.
-- -- Steve
If Teflon is too soft then consider Torlon. Machines very well, fairly high temperature, much lower thermal conductivity than metal. Just made a soldering fixture out of it yesterday. Quite expensive in sheet form, but rods aren't too bad.
There's also a glass-filled Teflon that's less mushy.
All are available from McMaster-Carr
Steve J. Noll | Ventura California | The Used Equipment Dealer Directory: |
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.