1. Home
  2. Electronics Design
  3. wiz-c problem

wiz-c problem

Hi all

I have a problem using the I2C module found within the WIZ C. I need the clock (SCL) to be less than 100kHz. The manual says that there is a

constant named IIStretch that enables the user to elongate the Data and

clock pulses with the integer set by this constant. This is done because as a default the WIZ C transmits data at 400KHz. Howewver, this

is not working since I verified with the WIZ C waveform analyser. Any suggestions please?

Thank you

Reply to
nvllfarrugia
Loading thread data ...

I hate the Appbuilder, learn C. Wiz is a pretty good 'C' compilier, and adhears to most, if not all, C conventions. You can mull on over to the Yahoo FEDPIC group and Find your answer.

Cheers

Reply to
Martin Riddle

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.