If you had to divide an audio frequency (at the point it needs to be divided, the signal will drive an 8 ohm speaker), using discrete components, not an IC, what would be the simplest means? Thanks in advance.
There are a lot of ways to "divide an audio frequency", but it all depends on what you're trying to divide. Do you just want to sound like Jabba or Darth? There's no simple way to do that, that I know of, unless you consider Digital Signal Processing simple: you'd be better off to get one of those Halloween voice warper mask toys and be done with it.
What I've done back in my disco/boom-box days (late '70's, early '80's)....
(1) Use an envelope detector to extract the amplitude variations
(2) Then square-up the input signal and divide by 2 digitally
(3) Use the "envelope" to modulate the amplitude of the divided-by-two signal.
(4) Filter with a sharp cutoff lowpass.
Sounds MUCH better than your classic boom-box crap which is usually just a regenerative distortion generator.
Makes Sousa and even Classical music sound great!
I have blue-prints of production designs that I can scan and post if there's an interest.
Caution: This can smoke ordinary woofers ;-)
...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC\'s and Discrete Systems | manus |
| Phoenix, Arizona Voice:(480)460-2350 | |
| E-mail Address at Website Fax:(480)460-2142 | Brass Rat |
| http://www.analog-innovations.com | 1962 |
The harder I work the luckier I get.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here.
All logos and trade names are the property of their respective owners.