Anyone happen to know the resistors or ratio to drop headphone level to microphone level? Thanks.
Headphone, Line, Microphone levels?
Dec 05, 2012
10 Replies
You have to know how much attenuation you need.
formatting link
Les Cargill
What sort of microphone?
Microphone input on a Tascam DR-07mkII.
formatting link
"Davej"
** There is no specific level for either.IME, headphone levels vary over a rage of 100:1 and mic levels vary over a rage of 1000:1
Try an attenuation of 100:1 ( 1kohms feed and 10ohms to common) and see how that goes.
.... Phil
OK, thats the INPUT, but what are you going to plug into that INPUT ??
H
Yahama P60 headphone output.
formatting link
Without knowing either device. Taking mic level at around 1 mv, and headphone level at 100 mv, probably 100:1 is a good place to start.
Regards,
Adrian Jansen adrianjansen at internode dot on dot net
Note reply address is invalid, convert address above to machine form.
Without knowing either device. Taking mic level at around 1 mv, and headphone level at 100 mv, probably 100:1 is a good place to start.
Regards,
Adrian Jansen adrianjansen at internode dot on dot net
Note reply address is invalid, convert address above to machine form.
00 (PST), Davej
most mixers generally have pad button for line/mic that is 20dB
-Lasse
1K to 10ohm "L" seems to work fine. Thanks. Now I just have to be careful that microphone power is never turned on.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required