Hello, All,
Yeah, it's another dumb Q. from Kris ;)
I'm looking at this:
formatting link
20a%20Boost%20Driver
In the column for "minimum LED current", there is a dash. Does that mean that, if I wanted, I could use the MicroPuck2009 to run 20mA, or does it mean it only had onle "flat-rate" output?
I understand that resistors control Voltage into LEDs. But how do I get something like this puck to not pump too many mA into fewer than the suggested 15-parallel-20mA-LEDs, say, 6 or maybe 8?
Many Thanks in Advance!
- Kris K.