Tiny Wire-Free LED Modules Powered by Magnetic Coupling

Nov 18, 2026 Last reply: 2 hours ago 2 Replies
Jump to replies (2)

Putting a light inside something sealed usually means a battery, and a battery means bulk, cost and a limited life. This build sidesteps that entirely: standalone LED modules that draw their power through magnetic coupling, with no connection of any kind to the light source.



The construction is refreshingly minimal. Each receiver is a surface-mount LED soldered to a small board along with a tuning capacitor, all mounted on a drum-core inductor. That inductor serves as the antenna, and the capacitor tunes it to the transmitter frequency. On the other side, a driver circuit board is soldered to a circular loop of copper wire, with red and black power leads feeding it. Two parts per receiver and one coil per transmitter is about as lean as a wireless power link gets.



The results look convincing. The modules illuminate in red, blue, green, yellow and white, and they glow brighter as they get closer to the center of the field. The maker positions them within or above the coil using tweezers, which gives a sense of just how small these receivers are. The field penetrates surfaces, and the maker suggests the modules could be cast into tabletop dice or game miniatures. Light-up dice with nothing but a coil underneath sounds like a genuinely fun outcome.



One thing is still unresolved: the inductors are marked 220, but the actual value has not been confirmed by the maker. Anyone replicating the receiver should treat that marking as a starting point rather than a specification. The brightness falling off away from the coil center is also worth planning around for anything larger than a single die.



Project by Proto G Engineering. Watch it on their YouTube channel:

formatting link


Those receiver modules look small enough to hide almost anywhere. My question is about the inductors: the marking reads 220, but that alone does not pin down the actual inductance for me. Does anyone know what value those drum-core parts are? I would like to put together a matching receiver and transmitter pair, and choosing the tuning capacitor depends heavily on getting that number right.

The maker has not stated the value. The parts are marked 220, and a figure of 22uH power inductors has been suggested, but nothing from the maker confirms it. If the exact inductance matters for the tuning capacitor, measuring a sample part before matching the transmitter coil seems like the safer route.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required