Finally got my bench power project past the first real milestone

Nov 19, 2026 Last reply: 20 hours ago 3 Replies
Jump to replies (3)

Spent the last few months on a programmable supply for my desk setup and the first board came back from fab this week. It powers up, the outputs switch, and the voltage readouts actually match my meter within a hair. Small win but it felt huge after three dead-end revisions. The idea is one box that replaces the snake nest of adapters under my bench. Multiple isolated DC outputs where you can set the voltage and a current limit per channel, plus USB ports for the smaller gadgets, all fed from a single brick. No more hunting for the right wall wart or frying a gadget because I grabbed the wrong plug.



The current limiting part was trickier than I expected. Getting per-channel control without the whole thing resetting when one output hiccups took a few tries. A readout showing what each port is doing in real time ended up being the feature I use most, even more than the adjustable voltage.



Enclosure is next. probaly 3D print a prototype first, then decide if it deserves milled aluminum. I'll keep posting as it comes togather.


I went down this same road a couple years back when I got tired of the pile of wall adapters by my bench. Mine is a lot humbler than yours, just a metal box with four buck converter modules and a Raspberry Pi watching everthing over USB. Works well enough that I stopped reaching for my bench supply for most small jobs.

The current limiting part burned me too. My first attempt sampled the current in software and by the time the code noticed an over-current, the channel had already sagged. What fixed it was using converter modules that do the current limiting in hardware with their own feedback pin, and only letting the software set the target. The micro handles the fast stuff, the Pi just watches and reports. One channel browning out no longer drags the others down with it.

Agree on the readouts being the sleeper feature. I can see at a glance that the thing plugged into port 3 is pulling way more than I thought, which has saved me from two bad cables and one dodgy LED strip. On the enclosure, I printed mine in PETG with vent slots on the ends and it has held up fine for two years. Consider leaving yourself extra room around the terminals than feels necessery. My hands were always too big for the first version and I ended up reprinting just for the extra finger space.

I ended up on the lazy version of this after my own attempt stalled out. Wanted adjustable everything like you built, but I could never get the per channel limiting to behave, so I flipped it around. Each output on mine is a fixed voltage that I picked once, and every one feeds through its own resettable fuse. Crude compared to what you've got, but a short just kills that one port and everything else keeps running. Zero resets, zero drama, and the fuse panels from a car parts aisle cost almost nothing. For the USB side I just used those cheap trigger boards that negotiate the voltage with the gadget. Way less fuss than building it myself and the gadgets seem happy. On the enclosure, my one warning from experiance is heat. I printed my first case and the plastic right above the guts went soft and sagged over a summer. Vented the next version and moved the warm parts away from the shell and it's been fine since. The readouts are worth it though. I thougth mine woud be a gimmick but I stare at them constantly, mostly to catch stuff drawing more than it should. Keep posting, the milled case idea sounds like a fun endgame.

Not sold on the Pi doing the watching, at least the way you describe it. USB polling means seconds between updates, so a channel can cook for a while before the screen shows it. Mine polls every couple seconds and I've caught a flaky cable only after it had allready melted its insulation a bit. If the readouts matter that much to you, I'd have the micro push changes over serial the moment a channel moves, not wait for the Pi to ask. Question though, does yours show current history anywhere or just live numbers? Live only, I'd miss the slow creep that tells you a cable is going bad.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required