Headphone headband and hinge rescue from the bin

Nov 18, 2026 Last reply: 59 seconds ago 2 Replies
Jump to replies (2)

This project started with a sad sight: a pair of Audio-Technica ATH-M50 headphones with a wrecked headband and broken hinges, headed for the rubbish. Instead of letting them go, the maker took the whole thing apart and rebuilt it, turning a throwaway job into a proper repair.



The teardown was methodical. Four screws came out of each ear cup enclosure to expose the internal drivers and wiring. The headband's red and black wires were then desoldered from the internal contacts, with polarity noted along the way to prevent phase issues. A small M-shaped metal strain relief clip and a cable grommet were extracted and saved for reassembly. The replacement headband, which has integrated wiring and hinges, was threaded into the ear cups, the wires were resoldered to the driver terminals, and the strain relief and housing screws went back in. Both earcups ended up fully reassembled.



A few details stand out to me. The workspace was properly set up, with a blue silicone soldering mat, precision screwdrivers and a soldering iron, and a small Phillips screwdriver did the screw removal. There is also a clear warning in the build about melting the internal plastic while soldering, which is exactly the kind of trap this repair hides. Best of all, apparently no special tools are needed beyond patience and a soldering iron, so most people with a basic bench could attempt it.



One trade-off is worth flagging: the worn ear pads were kept untouched at the customer's request, even as the headband and hinge assembly were replaced. The on-screen figures of 30$, 40$ and 1000$ also leave me curious about how the repair cost stacks up against a new pair.



Project by PhilStudio. Watch it on their YouTube channel:

formatting link


Noting the polarity before desoldering seems like the smartest move in the whole repair. It costs nothing, and getting it backwards would mean phase issues that are miserable to diagnose after reassembly. Extracting and reusing the strain relief clip and grommet was a good call too, since those small parts are easy to lose and hard to substitute.

Since the customer wanted the pads kept, a nice follow-up would be a second pass with fresh ear pads once the originals give out entirely. New pads would complement the new headband and hinge assembly nicely. Another idea: a low-temperature tip or some shielding around the solder joints would add margin against the melting risk the maker flagged.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required