Retro Hexagonal 3D-Printed Bookshelf Enclosures for a Speaker Kit

Nov 14, 2026 Last reply: 3 hours ago 4 Replies
Jump to replies (4)

The usual route with a kit like this is the flat-pack wooden box: sand it, finish it, and end up with a plain rectangle. Robert Cowan took a different path by turning the C-Note kit into a fully 3D-printable speaker project, with all the parts and files published on Makerworld. Instead of woodwork you get a retro hexagonal enclosure that prints as a single structure with an integrated bass port, internal ribs, a separate front baffle and a detachable grille.



The build looks carefully planned. The cabinet was modeled in SolidWorks, print layouts were prepared in Bambu Studio, and printing ran on a Bambu Lab H2S with a textured PEI sheet, though a large-format printer is required. The body uses marble PLA, the baffle is printed in stiff carbon-fiber-filled PLA, and the honeycomb grille is standard black PLA. Importantly, the internal air volume and port dimensions match the stock cabinet to preserve crossover tuning. Before designing anything, the maker assembled the stock kit first, both to judge whether the project was worth it and to set an acoustic baseline for comparison.



Small touches stand out. Sacrificial support plugs in the binding post holes pop out with a flat-head screwdriver, and the gold-plated posts sit in hexagonal recesses on the rear, aligned and hand-tightened with washers and hex nuts rather than hammered in, avoiding cracked plastic.



Results look promising: the rigid hexagonal geometry produced cleaner acoustic results than the wooden box, which had produced a boomy, boxy sound. The open question is damping, since internal mats showed minimal effect on measurements. Thin walls, ribs and low infill keep consumption to roughly 1.4 kg per enclosure, 2.9 kg per pair, under a designed sub-$250 target. Mind the 315 by 275 by 250 mm minimum build volume, and skip flexible PETG per the maker's advice.



Project by Robert Cowan. Watch it on their YouTube channel:

formatting link


Splitting the materials is the choice that stands out to me. A stiff carbon-fiber-filled PLA baffle with a marble PLA shell seems like a smart divide, because in my view the baffle is where rigidity matters most and the shell gets the nicer look. The trade-off is that filled filaments can be fussier to print. Keeping the stock internal volume and port dimensions untouched is equally clever, since the proven crossover stays valid without redesign.

One thing has me curious: did the internal damping actually move the needle? The test prototype was lined with damping material and foam sheeting, yet I would like to know whether the mats changed the measured results at all, or whether the printed walls with their ribs and low infill behaved differently from the wooden cabinet in that respect.

The maker has reported on exactly this. Internal damping mats showed minimal effect on the measurements. The test enclosure was lined with damping material and foam sheeting during testing, but the mats themselves did not register much change in the measured data, so the lining does not appear to be doing much that shows up in the numbers.

A compact sibling would be worth attempting. The current design demands a minimum build volume of 315 by 275 by 250 mm, so a version with a smaller side angle could bring the footprint down to fit a common 250mm cube build plate. That would let people with standard printers print the enclosures at full quality without splitting the structure, while presumably keeping the same drivers and tuning.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required