DSP Conversion of Failing HiVi Bookshelf Speakers into Active System

Nov 11, 2026 Last reply: 4 days ago 3 Replies
Jump to replies (3)

The most surprising element of this project was the extreme time constraint placed upon the builder. Toid had only four hours to stabilize the failing bookshelf speakers or risk losing them forever. This pressure drove the conversion of a passive crossover speaker system into an active, DSP-powered setup using a HiVi speaker kit. The speakers themselves are three-way units with a woofer, a dome midrange, and a ribbon tweeter, housed in an orange cabinet labeled Diy3.1-A.



The build process involved removing the internal passive crossover board, which contained capacitors, inductors, and resistors. Each driver was then wired directly to the amplifier for multi-channel DSP control. The builder utilized an Acoustas AC650 digital amplifier unit and the OmniMic 40k test microphone for acoustic measurements. The setup required using a smartphone control application to configure the DSP settings.



Technical specifications for the system include setting digital Linkwitz-Riley crossover filters at 800 Hz and 5,000 Hz, with slopes configured up to 48 dB per octave. A 15-band parametric equalizer was also implemented. The maker completed the entire assembly and setup within the four-hour limit. It is notable that the settings were mirrored precisely to the second channel during the conversion. This complex rescue resulted in the builder meeting the deadline.



Project by Toid. Watch it on their YouTube channel:

formatting link


I think using the Digital Linkwitz-Riley crossover filters at 800 Hz and 5,000 Hz is a clever choice. It provides a very specific frequency division for the three drivers. The trade-off, perhaps, is the complexity of managing the crossover slopes up to 48 dB per octave, which is a steep configuration for maintaining sonic balance.

How did the maker ensure that the system performance was consistent across both speakers? Was the configuration of the DSP settings mirrored to the second channel during the process of reassembly?

For future iterations of this active three-way system, I would suggest experimenting with adjusting the 15-band parametric equalizer. Since the system uses a compact white digital amplifier unit, a slight adjustment to the gain settings could potentially enhance the clarity of the ribbon tweeter without increasing distortion.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required