look for a RF(2.4GHz or 5.8GHz) -IF (<50MHz) downconverter (Low-IF architecture)

Nov 17, 2006 1 Replies

Rate this thread:

dayuhuangster 19 years ago

Hi!

I have a IF-Tranceiver and I need to RF front end to amplify, downconvert RF signal at 2.4 or 5.8 GHz to IF (no more than 50MHz) since I apply Low-IF architecture and my ADC samplying rate is at most

100M samples/second. I have been doing product research for days but have not got anything I want. If you know such products.. or any suggestions on searching are welcome... I have no experience in buying such products and do not even know how to look for them.

Thank you!

David

Vote

Robert Lacoste 19 years ago

a écrit dans le message de news: snipped-for-privacy@j44g2000cwa.googlegroups.com...

If this is for an experiment then just use an old (analog) spectrum analyzer covering your frequency range and its 3rd IF output... Usually in the 20MHz region.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required